FAQ

FAQ

While the edge of the film can be seen from certain angles, people generally do not notice it unless they are looking for it. However, if the car is dirty and dust and dirt is allowed to collect along the edge of the film, it will be more noticeable. Once the car is cleaned, it will be once again difficult to detect unless looking for it.
The XPEL ULTIMATE, STEALTH and XTREME warranty is not transferrable to another owner if the vehicle is sold.

It is highly unlikely for paint protection film to harm OEM paint. Paint systems used on modern assembly lines today produce a minimum bond strength of 16 MPa and maximum of 25 MPa between the panel and the paint depending on color, iridescence and the system used. Our film’s bond to the painted surface at normal state (immediately following installation) is .0753 MPa. Even after years of heat and sun, the bond between the film and the paint increases to only 0.17 MPa. What that means is in the absolute worst case scenario, the bond of factory paint to the panel is over 94 times stronger than the bond of our film to the paint. In the best case, the paint is 332 times stronger.

That being said, it is still recommended to have a professional remove the film in accordance with our published guidelines.More information can be found at http://www.xpel.com/postinstallation/care-instructions/ 

The self-healing clear coat of our ULTIMATE and ULTIMATE STEALTH films is designed to repair itself from swirl marks and light scratches from car washes, etc. If a piece of debris has penetrated all the way through the clear coat on the film, it will not self-heal. The only way to fix this would be to have the piece of film replaced.
If there is left over adhesive upon removal, you can use a general purpose adhesive remover, often found at your local auto parts or home improvement store.
Yes. XPEL film can be applied over a vinyl wrap or graphics. However, if there are any hard edges that film must cross (as in the case of stripes), it could result in some air being trapped along that edge.
If there is left over adhesive upon removal, you can use a general purpose adhesive remover, often found at your local auto parts or home improvement store.
Yes. Though you can install the film over any quality of touch-up, the best possible appearance will be obtained if the touched up area has been color-sanded smooth and buffed after the application of the paint.
Yes. XPEL can be installed on your cars headlamps and fog lamps
You may use any standard car wash soap, rinse free car wash, or detail spray to clean the film, provided that the product does not contain more than 5% naphtha or kerosene.
Yes. Any smooth painted surface can be covered with paint protection film.
Yes. But wait 48 hours after installation to allow the film to dry completely.
XPEL ULTIMATE is 8.5 mils (.0085 inches) thick.

FIND
YOUR KIT

Protect your car’s paint
Call Us Now
(907) 334 8088